Maintenance; Changing The Battery; Metrological Check - Chauvin Arnoux F11N Manual De Funcionamiento

For maintenance, use only specified spare parts. The ma-
nufacturer will not be held responsible for any accident
occurring following a repair done other than by its After
Sales Service or approved repairers.

14.1. Changing the battery

Never open the clamp without first disconnecting
it from all external electrical sources.
n The clamp must not enclose any conductor.
n No leads should be connected.
n Set the switch to the OFF position.
n Remove the screw from the lower case.
n Replace the used battery with a 9 V battery, preferably
alkaline (type IEC 6LF22 or NEDA 1604).
14.2. Cleaning
n The clamp must be deconnected from all electrical source.
n Keep the teeth of the jaws perfectly clean: they should be
cleaned with a soft, slightly oiled cloth.
n Clean the case with a cloth slightly moistened with soapy
water. Rinse with a dry cloth. Then dry quickly with a cloth
or in a hot air stream .

14.3. Metrological check

It is essential that all measuring instruments are regulary
calibrated.
For checking and calibration of your instrument, please con-
tact our accredited laboratories (list on request) or the
CHAUVIN ARNOUX subsidiary or Agent in your country.
14.4. Repairs under or out of guarantee
Repairs under and out of guarantee : please return the product
to your distributor.

14. MAINTENANCE

25