Maintenance - Chauvin Arnoux C.A 5205 Manual De Empleo

10 - MAINTENANCE

For maintenance, use only specified spare parts. The
manufacturer will not be held responsible for any accident
occurring following a repair done other than by its After
Sales Service or approved repairers.
10-1 Replacing the battery
The multimeter must be disconnected from any electrical
source.
I Place the selector switch on the «OFF» position.
I Unscrew the tool release screws and remove the lower half of the
case.
I Replace the dead batteries by two 1.5 V batteries (type LR6 or R6)
I Refit the lower half of the case
10-2 Storage
If the multimeter is not put into service for a time exceeding 60 days,
remove the batteries and store them separately.
10-3 Cleaning
I The multimeter must be disconnected from any electrical source.
I To clean the case, use a cloth slightly moistened with soapy
water. Rinse with a damp cloth. Then, dry rapidly with a cloth or in a
hot air stream.
10-4 Metrological check
Calibration
It is essential that all measuring instruments are
regularly calibrated.
For checking and calibration of your instrument, please contact our
accredited laboratories (list on request) or the Chauvin Arnoux subsidiary
or Agent in your country.
10-5 Repair
Repairs under or out of guarantee: please return the product to your
distributor.
15