Mondolfo Ferro AS 924 Manual De Uso página 117

Do not remove or modify any part of the machine (these interventions may only be
carried out by personnel of the technical support centres).
When disconnecting the machine from the compressed air supply, the pneumatic
actuators may still be pressurised.
Before carrying out any scheduled maintenance operation or topping up with lubricant,
disconnect the machine from the compressed air supply line.
The manufacturer declines all responsibility for claims resulting from the use of
non-original spare parts or accessories.
- Clean the machine regularly
- Keep all the guides (vertical axis, horizontal axis, clamping guides) clean and well lubricated
- The regulator filter unit plus lubricator (FRL)serves to filter the air, adjust the pressure
and lubricate it.
The "FRL" unit supports a maximum input pressure of 16 bar and has an adjustment range
of 0.5 to 10 bar. The setting may be modified by pulling the handle out and then turning.
After adjusting, return the handle to the locked position by pushing down (fig.42a).
The lubricant flow-rate is adjusted by turning the screw on part "L", (fig.42b); normally
this unit is precalibrated to a pressure of 10Bar, with SAE20 viscosity lubricant in order
to make a drop of lubricant come out, which can be seen from the specific cover, every
4 times the bead breaker is operated.
Regularly check the level of the lubricant through the designated inspection window and
top up as indicated in fig 42c. Only top up with 50cc of non-detergent oil SAE20.
The filter regulator "FR" has an automatic condensation drain system, therefore in condi-
tions of normal use special maintenance is not required. The condensate may however
be drained manually at any time (fig.42d). Normally the cups do not need to be removed,
but check if this is necessary for maintenance operations after a long period of use. If a
manual operation is not sufficient, use the specific key provided (fig.42e).
Clean with a dry cloth. Avoid contact with solvents.
NOTE: for the warning indications regarding oil, refer to the relevant chapter in the op-
erator's manual of the machine.
AS 924 - AS 924 A Operator's Manual
CAUTION
CAUTION
CAUTION
CAUTION
UK
117