Typical Installation; Important - Broan-NuTone HLB6 Instrucciones De Montaje

TYPICAL INSTALLATION

MOUNTING (New Frame Construction)
10" ROUND DUCT
TO 10" ROUND
TRANSITION
Blower factory-shipped
in horizontal
discharge position.
Factory-shipped unit installed in new construction.
MOUNTING (Existing Frame Construction)
2 X 4 FRAMING
(wide side down)
4½" X 18½"
TO 10" ROUND
TRANSITION
10" ROUND
DUCT
MOUNTING
BRACKETS
(Attached to
opposite sides
of housing &
upside-down,
CEILING JOIST
so housing is
(24" centers
flush with
finished ceiling)
Blower factory-shipped in straight-through
discharge position.
4½" X 18½"
Mounting brackets
y
factory-shipped in
position for ½"
ceiling material.
y
(24" centers
10" ROUND
4½" X 18½"
TO 10" ROUND
MOUNTING
TRANSITION
SCREW
4½" X 18½" TO 10"
ROUND TRANSITION
10" ROUND
MOUNTING
shown)
TYPICAL INSTALLATION
MOUNTING USING HANGER KIT (included)
CEILING
JOIST
HANGER
KIT CHAIN
shown)
HANGER
KIT
EYE-BOLT
4½" X 18½"
TO 10"
ROUND
TRANSI-
TION
DUCT
10" ROUND
DUCT
(OUTLET)
Blower factory-shipped in straight-through
DUCTING (Straight-through blower discharge)
10"
DUCT
ROUND
DUCT
SCREW
Two ways to connect ductwork to a factory-shipped unit.
IMPORTANT: Remove shipping tape from damper
Remove the shipping tape from the damper flap and make sure
that damper flap opens and closes freely inside the ductwork. Use
duct tape to make ductwork connections secure and air-tight.
ACCESS
PANEL
discharge position.
4½" X 18½"
TO 10" ROUND
TRANSITION
ROUND
DUCT
10"
ROUND
ELBOW
Page 2
HANGER
KIT BOLT
& WASHER
EXTENSION
SPRING
10" ROUND
DUCT (INTAKE)
HANGER
KIT NUT &
WASHER
MOUNTING
BRACKET
GRILLE NUT
(Install into
square holes in
housing)
ACCESS
PANEL SCREW
ROOF CAP
10"
WALL
CAP