General Information; Safety Information - Heidolph MR 3003 control Manual Del Usuario

E

GENERAL INFORMATION

Unpack your item carefully.
Inspect for damage and report such damage or missing parts to your supplier right away.
Read your instruction manual carefully. Take time to save time while trying to work with your
item. Make sure that every user has read and understood the instruction manual.
Please locate the instruction manual in a place easily accessible to every user.
IF ALL ELSE FAILS, READ THESE INSTRUCTIONS !
A so called EURO- plug (DIN 49441 CEE 7/VII 10/ 16 A 250 V) is standard on all of the items.
For the Continental US they feature a US-standard plug (NEMA pub.no.WDI.1961 ASA C
73.1.1961 page 8 15A 125V).
For using the item in a country with deviating outlet / plug systems, we recommend to use ap-
proved adapters or to have an electrician replace the standard plug with one suiting your needs.
As shipped, the item features a protective ground wire. When replacing the original plug, make
sure to re-connect this protective ground wire in the new plug !

SAFETY INFORMATION

Please comply with all safety and accident-prevention regulations as in force for labora-
tory work !
Use extra care when working with flammable substances; refer to safety data sheets.
When connecting your item with your local power supply, please make sure your item is
designed for your local supply voltage; go by data plate on the item.
Turn your power switch OFF whenever the item is not used, or before disconnecting the
plug.
Repair work is limited to technicians approved by Heidolph Instruments.
Use extra care when working in the vicinity of flammable and explosive substances. Mo-
tors are of non-sparking type, the item itself however is not explosion-protected.
Please connect your magnetic stirrer with a protective-ground outlet only.
Caution! Hazard of serious burns when running the hot plate over 50 °C.
Avoid contact with hot plate, bath and fluid.
Caution! When heating flammable substances, adjust hot plate nominal temperature to a
lower level than the substance's flashpoint.
Your item needs a solid stand.
22