Andset; Wall Mounting Theb - GE 25831 Guia Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

I
NSTALLING THE
NOTE: You must connect the handset battery before use.
1. Locate battery and battery door which are packaged together inside a plastic
bag and are separate from the handset.
2. Locate the battery compartment on the back of the handset.
3. Plug the battery pack cord into the jack inside the compartment.
NOTE: It is important to maintain the polarity (black and red wires) to the
jack inside the compartment. To ensure proper battery installation, the
connector is keyed and can be inserted only one way.
4. Insert the battery pack.
5. Close the battery compartment by pushing the door up until it snaps into place.
6. Place the handsets in the charging cradle.s
Allow handsets to charge for 16 hours prior to first use. If you don't properly
charge the handsets, battery performance is compromised.
W
M
ALL
OUNTING THE
NOTE: For best results, leave the phone on a flat surface during initial
charging before you hang the phone on the wall.
1. Turn the base over.
2. Attach the wall mounting pedestal by first inserting the tabs on the open edge
of the pedestal into the slots on the lower portion of the bottom of the base.
Then push down and snap the pedestal into place.
3. Slip the mounting holes (on the back of the pedestal) over the wall plate posts
and slide the unit down into place. (Wall plate not included.)
12
H
B

ANDSET

ATTERY
PRESS
B
ASE
BATTERY
BLACK
RED

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido