Kohler Sterling 4700 Serie Manual Del Usuario página 15

8-32 x 1/4"
Hanger
Barrel
Bracket
Nut
Sex Bolt
Gasket
9. Install the Rollers
Install the Hanger Brackets
Position a gasket on the top of the glass panel, with the holes in the glass and gasket aligned.
Repeat for each hole, four total.
Press a hanger bracket over each gasket and align the holes.
While pressing down on each hanger bracket, use a screwdriver to thread a sex bolt into a barrel
nut.
Tighten securely.
NOTE: The steel side of the roller must be installed against the hanger bracket.
Install the Outside Panel Rollers
IMPORTANT! If the glass panels have a textured side, install both rollers on the textured side of the
panel. If the glass panels are smooth on both sides, make sure that both rollers are installed on the same
side of the panel.
Assemble the rollers and #8-32 x 3/8" screws through the center hole of each hanger bracket.
Install the Inside Panel Rollers
IMPORTANT! If the glass panels have a textured side, install both rollers on the smooth side of the
panel. If the glass panels are smooth on both sides, make sure that both rollers are installed on the same
side of the panel.
Assemble the rollers and #8-32 x 3/8" screws through the center hole of each hanger bracket.
Sterling
Inside Panel
x2
No Gap
at Top
Roller
Screw
#8-32 x 3/8"
15
Label Side
#8-32 x 3/8"
Screw
Label
Rollers
Outside Panel
Label Side
Label
1211021-2-A