Kohler Sterling 4700 Serie Manual Del Usuario página 7

#8-18 x 1-1/4"
Panhead Screw
#8-18 x 1-1/4"
Panhead
Screw
2. Install the In-Line Panels
NOTE: The in-line panel can be installed on either side of the doors.
Place a non-adjustable in-line connector jamb over one end of the knee wall in-line panel.
Drill three 1/8" (3 mm) diameter holes and secure the in-line connector jamb to the in-line panel
with #8-18 x 3/8" screws.
Insert the connector jamb and in-line panel assembly into the transition jamb.
Secure with three #8-18 x 1-1/4" screws.
Slide the in-line connector jamb onto the adjustable in-line connector. Fit this assembly over the
opposite end of the in-line panel.
NOTE: Do not adjust and secure the in-line panels until the bottom track and door wall jambs have been
installed. Use masking tape to temporarily hold the panels in position.
Sterling
#8-18 x 3/8"
Panhead Screw
End Panel
Non-Adjustable
In-line Connector
Jamb
#8-18 x 3/8"
Panhead Screw
90˚
Transition
Jamb
Adjustable
In-line
Connector
In-line
Connector
Jamb
7
In-line
Panel
1211021-2-A