Kohler Sterling 4700 Serie Manual Del Usuario página 9

Measure
here.
Curved Base
Important:
3. Measure and Cut the Bottom Track
CAUTION: Risk of personal injury. Always wear safety glasses when cutting materials.
Measure from the wall to the knee wall edge at the flattest part of the shower ledge (dimension
"D").
Mark dimension "D" on the bottom track.
IMPORTANT! For best results, use a 32 teeth per inch hacksaw blade and a miter box to cut the bottom
track.
Subtract 7/8" (22 mm) from dimension "D" and cut the bottom track to this dimension.
File the rough edges smooth where the bottom track was cut, taking care not to mar the finished
surface.
NOTE: If there are curves where the sidewalls meet the threshold, use a file to contour the bottom track
edges to match the curves.
Sterling
Measure carefully. If your walls are curved or
angled, measure above the curve or angle. Failure
to do so can result in an improperly cut bottom
track.
D
9
Measure
here.
Angled Base
1211021-2-A