To Replace The Blades; Replace The Blades; Troubleshooting - Husqvarna AUTOMOWER 105 Manual Del Usuario

CAUTION: The battery must be
charged fully before winter storage. If
the battery is not fully charged it can
be damaged and in certain cases be
rendered useless.
The charging time can vary depending on,
among other factors, the ambient temperature.
Below indicates that the battery is getting old and
eventually needs replacing:
• The operating time for the product is shorter
than normal between charges. This leads to
more charging cycles than normal, which
increases the risk of tracks forming near the
charging station.
• The product is found standing out on the
Empty battery message. This
lawn with
indicates that the product does not have
battery capacity enough to find the charging
station.
The battery is fine as long as the product
maintains a well-cut lawn.
Note: Battery life is dependent on the length of
the season and how many hours a day the
product is operating. A long season or many
hours of use a day means that the battery must
be replaced more regularly.
Contact your local Husqvarna representative to
replace the battery.

5.3 Replace the blades

WARNING: Use blades and screws of
the right type. Husqvarna can only

6.1 Troubleshooting

In case of malfunction, a message will appear on the display. For more detailed information on
messages, refer to the complete Operator's manual on Husqvarna's website (www.husqvarna.com. If
the same message appears often or if you still cannot find the reason for the fault, contact your local
Husqvarna representative.
Breaks in the loop wire are usually the result of unintentional physical damage to the wire such as
when gardening with a shovel. Breaks can also be due to the wire being stretched excessively during
installation. A wire break can be located by gradually halving the distance of the loop where the break
1194 - 001 - 23.05.2019
Replace worn or damaged parts for safety
reasons. Even if the blades are intact, they
should be replaced on a regular basis for the best
mowing result and low energy usage. All 3 blades
and screws must be replaced at the same time to
obtain a balanced cutting system. Use
Husqvarna original blades embossed with the
crowned H-mark logotype, refer to
terms on page 26 .

5.3.1 To replace the blades

1. Set the main switch to position
2. Turn the product upside down. Place the
product on a soft and clean surface to avoid
scratching the body and the hatch.
3. Rotate the skid plate so that its holes align
with the screws for the blade.
4. Remove the 3 screws. Use a straight slot or
cross-tip screwdriver.
5. Remove each blade and screw.
6. Fasten new blades and screws.
7. Check that the blades can pivot freely.
6 Troubleshooting
guarantee safety when using original
blades. Only replacing the blades and
reusing the screw can result in a screw
wearing during mowing. The blades
can then be propelled from under the
body and cause serious injury.
Warranty
Troubleshooting - 19
0 .