Led Indicator Lamp On The Charging Station; Transportation, Storage And Disposal; How To Lift And Move The Product - Husqvarna AUTOMOWER 105 Manual Del Usuario

may have occurred, until there is only a very short section of the wire left. Refer to the complete
Operator's manual on Husqvarna's website (
6.1.1 LED indicator lamp on the charging
station
For a fully functional installation, the LED indicator lamp on the charging station must emit a solid or
flashing green light. If something else appears, follow the troubleshooting guide below.
There is more help on www.husqvarna.com. If you still need help, please contact your local Husqvarna
representative.
Light Cause
Solid green light
Good signals
Green flashing
The signals are good and
light
activated.
Blue flashing light
The boundary loop is not connected to
the charging station.
Break in the boundary loop.
Yellow flashing
The guide wire is not connected to the
light (Automower ®
charging station.
105)
Break in the guide wire.
Red flashing light
Interruption in the charging station's an-
tenna.
Solid red light
Fault in the circuit board or incorrect
power supply in the charging station.
The fault should be rectified by an au-
thorized service technician.

7 Transportation, storage and disposal

7.1 Transportation
The supplied Li-ion batteries obey the Dangerous
Goods Legislation requirements.
• Obey all applicable national regulations.
• Obey the special requirement on package
and labels for commercial transportations,
including by third parties and forwarding
agents.
20 - Transportation, storage and
disposal
www.husqvarna.com ).
Action
No action required
ECO mode is
No action required.
Check that the boundary wire connec-
tors are fitted properly to the charging
station.
Find out where the break is. Replace
the damaged section of the loop with a
new loop wire, and splice using an
original coupler.
Check that the guide wire connector is
properly connected to the charging sta-
tion.
Find out where the break is. Replace
the damaged section of the guide wire
with a new loop wire and splice using
an original coupler.
Contact your local Husqvarna repre-
sentative.
Contact your local Husqvarna repre-
sentative.
• For how to remove the battery, refer to the
complete Operator's manual on
www.husqvarna.com.

7.1.1 How to lift and move the product

To safely move from or within the work area:
1. Press the STOP button to stop the product.
If security is set to the medium or high level
the PIN code has to be entered. The PIN
1194 - 001 - 23.05.2019