Troubleshooting; Indicator Lamp In The Charging Station - Husqvarna AUTOMOWER 105 Manual De Usuario

Ocultar thumbs Ver también para AUTOMOWER 105:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6.
Fasten new blades and screws.

6.1 Troubleshooting

In case of malfunction, a message will appear on the display. For more detailed information on
messages, refer to the complete Operator's manual on Husqvarna's website
(www.husqvarna.com. If the same message appears often or if you still cannot find the reason
for the fault, contact your local Husqvarna representative.
Breaks in the loop wire are usually the result of unintentional physical damage to the wire such
as when gardening with a shovel. Breaks can also be due to the wire being stretched excessively
during installation. A wire break can be located by gradually halving the distance of the loop
where the break may have occurred, until there is only a very short section of the wire left. Refer
to the complete Operator's manual on Husqvarna's website (

6.1.1 Indicator lamp in the charging station

For a fully functional installation, the indicator lamp in the charging station must emit a solid or
flashing green light. If something else appears, follow the troubleshooting guide below.
There is more help on www.husqvarna.com. If you still need help, please contact your local
Husqvarna representative.
Light
Cause
Green solid light
Good signals
Green flashing
The signals are good and
light
is activated.
Blue flashing light The boundary loop is not connected
to the charging station.
Break in the boundary loop.
Red flashing light Interruption in the charging station's
antenna.
Red solid light
Fault in the circuit board or incorrect
power supply in the charging station.
The fault should be rectified by an
authorized service technician.
1418 - 004 - 10.03.2020
7.
Check that the blades can pivot freely.
6 Troubleshooting
Action
No action required
ECO mode
No action required.
Check that the boundary wire con-
nectors are fitted properly to the
charging station.
Find out where the break is. Replace
the damaged section of the loop with
a new loop wire, and splice using an
original coupler.
Contact your local Husqvarna repre-
sentative.
Contact your local Husqvarna repre-
sentative.
www.husqvarna.com ).
Troubleshooting - 23

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido