Silvercrest SRR 3.7 B2 Instrucciones De Uso página 25

5) Replace the cutter block 2 . Refer to figure 1 for
assistance:
Insert the 3 shaving heads in the recesses of the
–
cutter block 2 . Ensure that the notches on the
edge of the shaving heads rest on the catches in
the opening .
Place the round blades into the shaving heads .
–
Replace the shaving head holder, press it down a
–
little and slightly turn the gear wheel clockwise .
If the holder for the shaving heads cannot be reat-
tached, it may be that the gear wheel is a little skew.
In this case, turn the gear wheel counter-clockwise
again up to the stop. The holder for the shaving heads
can then be fitted.
The cutter block 2 is now installed again .
6) Remove loose hairs from the shaver with the brush e .
7) Replace the cutter block 2 on the shaver . Ensure
that it snaps into place and is seated firmly .
Clean the housing with a damp cloth .
■
SRR 3.7 B2
│
21
US-EN
■