Additional Information; Troubleshooting - Pioneer X-SMC5-K Manual De Instrucciones

15

Additional information

Chapter 15:
Additional information

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this
component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components
and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your
nearest Pioneer authorized service center or your dealer to carry out repair work.
• If the unit does not operate normally due to external effects such as static electricity disconnect the power plug from the
outlet and insert again to return to normal operating conditions.
General problem
Problem
Settings you have made have
been cleared.
Power can't be turned ON.
Difference in volume
between DVDs, CDs, MP3,
WMA, iPod/iPhone and
Tuner.
This unit cannot be operated
with the remote control.
The unit automatically turns
off or the demonstration
screen automatically starts.
44
En
Check
Was the power cord unplugged
forcibly while this unit's power was
on?
Is the Quick Start Mode set to On?
This is not a problem with this unit.
Are you operating from far away?
Is the remote control sensor exposed
to direct sunlight or strong artificial
light from a fluorescent bulb, etc.?
Are the batteries dead?
Is Auto mode select set to Power
Save mode or Demo Mode?
Remedy
Be sure to press STANDBY/ON on this unit's top panel or press
STANDBY/ON on the remote control and wait for the POWER ON
indicator on the front panel display to turn off before unplugging
the power cord.
If the power cord is disconnected while Quick Start Mode is set to
On, the next time the plug is reconnected, about one minute warm-
up will be required before the unit responds. Wait for one minute
after reconnecting the cord before pressing STANDBY/ON.
The volume may sound differently depending on the input source
and recording format.
Operate from within a distance of Operate within 7 m, 30° of the
remote sensor on the front panel (page 6).
The remote control signals may not be received properly if the
remote control sensor is exposed to direct sunlight or strong
artificial light from a fluorescent bulb, etc.
Replace the batteries (page 6).
Change the setting of Auto mode select to Off (page 32).