Tripp-Lite SmartOnline 7.5kVA Manual Del Propietário página 3

Mounting (Rack)
Mount your equipment in either a 4-post or 2-post rack or rack enclosure.The user must determine the fitness of hardware and procedures
before mounting. If hardware and procedures are not suitable for your application, contact the manufacturer of your rack or rack enclosure.
The procedures described in this manual are for common rack and rack enclosure types and may not be appropriate for all applications.
Note: The power module and battery module must be installed in separate shelves.
4-Post Mounting
1 Connect the two segments of each shelf
wing nuts B . Leave the screws slightly loose so that the shelves can be adjusted in
the next step.
Adjust each shelf to fit your rack, then mount them in the lowest available space
2
of your rack with the screws, nuts and washers provided
ledges should face inward. Tighten the wingnuts that connect the shelf segments
Attach mounting ears E
3
the screws provided G . The ears should face forward.
Using an assistant, lift your equipment and slide it onto the mounting shelves.
4
Attach your equipment to the rack by passing the screws, nuts and washers
(user-provided) H through its mounting ears and into the rack rails.
2-Post (Telecom) Mounting
To mount your equipment in a 2-post rack, you must purchase a Tripp Lite 2-Post
Rackmount Installation Kit (model: 2POSTRMKIT, sold separately) for each module
installed. See the Installation Kit's owner's manual for complete mounting instructions.
using the included attached screws and
A
to the front mounting holes of your equipment
C . Note that the support
D .
F using
3
B
A
1
C
2
F
E
3
H
4
B
D
G