Tripp-Lite SmartOnline 7.5kVA Manual Del Propietário página 9

Connection
Cold Start (optional): To use your UPS as a stand-alone power source when
AC input power is unavailable (i.e. during a blackout), you can "cold start"
your UPS and power connected equipment from the UPS's battery. Your UPS's
battery must be at least partially charged for this operation to succeed. Press
and hold the "ON" Button
LCD Display will show ON BATTERY MODE. Battery power will begin
H
discharging. Some electronic equipment may draw more amps during startup;
when cold starting, consider reducing the initial load on the UPS.
Configure UPS output: Put the UPS into bypass mode by holding the OFF
button down until the UPS beeps, then put the UPS into setup mode by
K
holding down both of its scroll buttons
options and select the appropriate setting for each of the following options.
Output Voltage: Select 200, 208, 220, 230 or 240V AC.
Output Frequency: The UPS will automatically select 50 or 60 Hz to match
the input.
Economy Mode: The UPS can provide true on-line operation with zero trans-
fer time. It can also operate in a more energy-efficient line-interactive mode.
Select "Economy On" to put the UPS in line-interactive mode. Select
"Economy Off" to put the UPS in on-line mode. After setting these options,
exit the setup mode with the scroll buttons
ing the ON button
I
Turn UPS output power ON: Press the ON button
Turn the UPS Output Circuit Breakers
Breakers are located on the detachable PDU
Switch from BYPASS to NORMAL. The UPS will now provide output
L
power through its AC outlets
Power OFF (optional)
Turn UPS inverter OFF: Press the UPS's "OFF" Button
beep. Your load will still be energized. The inverter is now off, but your UPS
is not fully deactivated. The LCD Display
Turn UPS output power OFF: Turn off the Output Circuit Breakers
ed on the detachable PDU
LCD Display will be dark.
Plug Your Equipment into the PDU's Outlets.
5
Your UPS is designed to support electronic equipment only. You will overload
your UPS if the total VA rating for all the equipment you connect exceeds the
UPS's output capacity. Do not connect household appliances or laser printers
to the UPS's outlets. To find your equipment's VA ratings, look on their name-
plates. If the equipment is listed in amps, multiply the number of amps by the
input voltage (240V, 208V or 120V) to determine VA. (Example: 1 amp × 120 =
120 VA).
Optional Connection
The following connections are optional. Your UPS system will function properly
without these connections.
RS-232 Serial Communication Connection
1
Use the included cable
the communication port on your computer. This will allow full network
monitoring and control of your UPS system. Install on your computer the
Tripp Lite PowerAlert Software appropriate to your computer's operating
system.
continued
until you hear a beep to cold start your UPS. The
I
at once. Scroll through the setup
J
, then exit bypass mode by hold-
J
down until the UPS beeps.
ON. (The UPS Output Circuit
M
O
to connected equipment.
N
will show BYPASS MODE
H
. Your load will no longer be energized, and the
O
A to connect the power module's RS-232 port to
until the UPS beeps.
I
.) Turn the Manual Bypass
until you hear a
K
locat-
M
9
M
N
4b
5
A
1a/1b
L
O
B