BEARWARE 303457 Manual página 24

Once the attempt to receive a signal fails, the weather station stops scanning after
about 5 minutes. The DCF symbol disappears from the display.
Caution! Remember that some devices may be sources of interference for receiving
the signal, such as televisions, computers, etc. You may have problems in receiving
the signal in closed areas such as an airport, factories, cellars etc.
7. Basic settings
Note: When the backlight is switched off ("backlight" switch in Off position),
the backlight can be turned on for approximately 5 seconds by pressing the
large "SNOOZE / LIGHT" button at the top of the housing.
Press and hold the "TIME SET" button for about 3 seconds to modify the basic
settings. With the "CHANNEL/+" and "MEM / _ " buttons you can change the
values accordingly.
By briefly pressing the "TIME SET" button, you can confirm the entry and proceed
to the next option. In this way, you can change and customise the following
settings in the sequence mentioned below:
• 12/24 hour format
• Hour
• Minute
• Second
• Year
• Month / Day format
• Month
• Day
• Time zone - Note: If you set the time zone, for example, to + 01 and the weath-
er station is actuated using the DCF-signal, then the clock displays one hour
later than the DCF-signal.
• Language setting - To set the day on the display. The following codes can be
configured and selected using the "UP" and "DOWN" buttons: EN (English), RU
(Russian), NL (Dutch), IT (Italian), ES (Spanish), DE (German), FR (French)
• RC - Enable or disable the DCF signal function.
• DST - Enable or disable automatic switching to daylight saving time.
24
English