BEARWARE 303457 Manual página 29

2. Press the "ALERT" button to switch between the "HI" and "LO" temperature
channels.
3. Press the "CHANNEL / +" button or the "MEM / -" button to change the
value.
4. To set the temperature value "Hi" or "Lo", press the "ALARM" button at the
top of the weather station to turn the HI / LO alarm on or off.
5. Once you finish, press and hold the "ALERT" button for about 2 seconds.
The display changes back to the time mode. Alternatively, the device
automatically returns to the time mode after about 60 seconds after the
last button is pressed.
6. The setting sequence: Channel --> "Hi" temperature alarm --> "Lo" temper-
ature alarm --> Channel
When the alarm is activated, it can be heard audibly and the icon flashes on the
display. Press the "ALARM / SNOOOZE", "ALARM" or "ALARM" button to stop the
alarm. If you ignore the alarm, it stops after 2 minutes.
Note: You cannot enter contradictory HI / LO values in the setting. If the HI tem-
perature value, for example, is 40° C, you cannot set the LO alarm to more than
39.9 °C, etc.
When an alarm is activated in Auto Cycle mode, the display switches to the
corresponding channel. You can press "ALARM / SNOOZE", "ALARM" or "ALERT".
Alternatively, the alarm stops automatically after 2 minutes. The display returns to
Auto Cycle mode.
English
29