BEARWARE 303457 Manual página 27

Low battery:
If the battery symbol appears, then the inserted batteries are discharged and
should be replaced with new batteries as soon as possible. This applies to the
outdoor sensor as well as to the base station. If the empty battery icon appears
next to the inside temperature, the battery of the weather station is empty.
Outdoor temperature display:
The outdoor temperature is measured by the outdoor sensor and shown to an
accuracy of one tenth of a degree. The configured temperature unit is shown to
the right of the measured value. The temperature unit can be changed between
°C and °F. To do this, slide the °C / °F switch on the back of the weather station to
the desired position.
Channel display
The weather station receives the signal of the outdoor sensor automatically. You
can switch between the different channels using the "CHANNEL/+" button. Select
the same channel, which you select for the outdoor sensor. The channels of the
outdoor sensor can be selected on the device directly using a toggle switch. The
Auto Cycle mode can be turned on by pressing and holding the "CHANNEL / +"
button for about 2 seconds.
Receiving the outdoor sensor signal
The outdoor sensor sends a signal twice a minute, which is automatically received
by the base station. You can also manually enable the signal reception. Press
the "Sensor" button on the back of the device until the scan icon (" ") starts
flashing. Once the signal has been successfully received, the animation of the
symbol disappears and the received temperature is shown on the display of the
weather station.
Frost icon
With the temperature alarm, the base station shows a " " icon in the display
when the temperature falls below the 3°C mark in the outdoor display.
27
English