Connect Ductwork - Broan-NuTone Rangemaster RMP1 Serie Manual Del Usario

CONNECT DUCTWORK

Ducted configuration
1. Take the discharge collar and assemble
it onto the hood's discharge opening,
pressing slightly.
2. Use 6" round metal duct to connect the
discharge collar on the hood to the
ductwork above.
3. Use duct tape to make all joints secure
and air tight.
Non-ducted recirculation configuration
1. Connect a 6" round metal duct to the range
hood's discharge opening.
Exhaust air must be discharged back into
the room.
Do not exhaust air into spaces within walls,
ceilings or into attic's, crawl spaces or
garage.
2. Purchase metal duct, elbows and grille
separately.
3. Use duct tape to make all joints secure
and tight.
CABINET UP TO THE CEILING
GRILLE
DISCHARGE OPENING
NON-DUCTED RECIRCULATION
FILTER INSTALLATION
1. Position the filters over the blower.
2. Rotate to lock filters in place.
3. Purchase replacement filter packs
(contains 2) from your dealer.
Part No. B03300487.
NON-DUCTED RECIRCULATION CONFIGURATION
90 DEGREE
ELBOW OR
BOOT
6" ROUND
METAL DUCT
- 6 -
DUCTED CONFIGURATION
DISCHARGE
OPENING
SHORT CABINET
DISCHARGE OPENING
NON-DUCTED
RECIRCULATION FILTERS
6" ROUND
METAL DUCT
DISCHARGE
COLLAR
6" ROUND
METAL DUCT