Trix 23420 Manual De Instrucciones página 6

Replacing a Defective Light Bulb
The light bulb is available under item no. 113579
at your authorized dealer.
Lift the body off with a flat-blade screwdriver at
the 3 openings in the floor on both sides of the
car. Leave the interior details piece on the car
floor. Unsolder the wire at the light diffuser. Pull
down the contact bracket with a flat screwdriver
at Point „g", then unsnap it at Projection „h".
Then, carefully lift the contact bracket at Point
„g" and loosen from the pin at Point „g" on the
interior detail piece. The contact bracket can
now be removed completely. Loosen the second
6
contact bracket on the same side of the car in the
same manner. The light diffuser can be removed
from the interior detail piece. Remove the silver
film and the adhesive film in the center of the light
diffuser, and replace the light bulb. Apply new
adhesive film and then siver film. Insert the light
diffuser between the contact brackets on one
side of the car and the interior detail piece. Make
sure that the Hole „c" in the light diffuser comes
on the Pin „b" on the interior detail piece and that
the arched side of the light diffuser faces up.
Putting the contact brackets back in place:
3.