Important - Hoover PROFESSIONAL Serie Manual Del Usuario

Getting Started With Your PowerDash
How to Clean Carpets with your PowerDash
1
Plug power cord into
electrical outlet.
2
Step on the Handle
Release Pedal to recline
the unit for cleaning
position.
3
Step on ON/OFF
Pedal to turn ON.
Carpet Cleaner:
™
:
™
4
Squeeze trigger for a slow
forward and backward
wet stroke* .
5
Release trigger for a slow
forward and backward dry
stroke* .
*follow these steps for best results

IMPORTANT

!
For full suction, it is important that the Dirty Water Tank
is properly secured before cleaning.
CAUTION
! !
Do not clean over floor electrical outlets. Water will drip
from the brushes and underside of the product after use
and may puddle. To avoid damage to wood and laminate
flooring and to avoid potential slip hazard, after use (a)
do not leave the product on wood and laminate surfaces
and move to a hard surface and (b) place unit on an
absorbent material (such as a towel) to soak up drips.
Continue using dry strokes until little water is visible
passing through the nozzle.
For best results, Hoover recommends rinsing carpet
with water only. This removes residual carpet cleaning
solution. Fill Solution Tank with water and repeat. For
heavily soiled areas, repeat. Avoid saturating carpet.
NOTE: Empty Dirty Water Tank when the motor sound
becomes higher pitched and there is a loss in suction
(see "Automatic shut-off"). You will also see the float
rise and shut off suction at the same time.
!
11