Jacobsen CV Serie Manual De Seguridad Y Operacion página 16

ASSEMBLY AND SETUP
GB
4. Loop chain connector D through both chains
and through the hole E on the cutter deck.
5. Level cutter deck
a) Place cutter deck in lowest cutting
position. See ADJUSTMENTS section.
b) Place block(s) under inside of deck to
level.
c) When deck is level, note position of chain
F. Chain should be taut. Adjust eyebolt G
as necessary.
6. Set deck to desired height of cut. See
ADJUSTMENTS section.
GB-14
JACOBSEN HR9510
SAFETY & OPERATION MANUAL