Kohler STERLING 6205 Serie Guia De Instalacion página 11

7. Cut Holes for Valves
NOTE: ADA specifies general locations where the shower controls and the showerhead must be located.
Lay out and mark the location of the mixing valve and shower on the back surface of the surround
wall.
Drill 1/4" (6 mm) pilot holes at the marked locations.
Clean the receptor to reduce the risk of surface damage.
Verify that there is a protective covering in the receptor.
IMPORTANT! If using a round hole saw or other rotary tool to cut the holes, cut the holes from the front
or finished side of the wall. If using a saber saw or other reciprocating saw with a blade that cuts on the
pull stroke, cut the holes from the rear of the wall. If using a hand-held jig saw or other saw that cuts on
the push stroke, cut the holes from the front of the wall.
Use a hole saw of the correct diameter to carefully drill the fitting holes.
Clean any debris from the receptor to reduce the risk of surface damage. Be careful not to scratch
the surface of the product.
Sterling
1. Mark center
of valves. Drill
pilot holes from
back side.
11
2. If using a hole
saw, cut holes
from front side.
1016220-2-C