ENGLISH
Replacing the DOSING ROLLER
Empty hopper
Hopper with product:
Then empty the dosing chamber.
IMPORTANT: before starting seeding, open the panel (P, Fig.
16) to feed the doser.
FEELER PIN
The feeler unit
Always use gloves. The new parts especially might have sharp edges that could injure the operator!
During re-assembly, before tightening the various parts, ensure that the rear part
of the hatch (on the spring side) is not too high. Install the dosing roller in order
to ensure that the height is correct.
USE AND MAINTENANCE
WARNING
H
G
cod. G19503101