Adapting The Cardan Shaft - GASPARDO PRIMAVERA Empleo Y Mantenimiento

4.1.2 ADAPTING THE CARDAN SHAFT

SLIPPAGE OF THE PTO SHAFT.
Inspections at work:
Telescoping tubes must always overlap by at least 1/2 of their
length in normal operation and at least 1/3 of their length in
all working conditions. During maneuvers, when the driveline
is not rotating, the telescoping tubes must have a suitable
overlap to maintain the tubes aligned and allow then to slide
freely.
Inspections in the raised position:
cod. G19503101
USE AND MAINTENANCE
L min.
4 cm
If these two results are not obtained:
A
C
during the lifting phase.
- Telescoping tubes must always overlap by at least 1/2 of their
length in normal operation and at least 1/3 of their length in
all working conditions. When it is inserted all the way, the
minimum admissible play is 4 cm.
- When using the equipment on another tractor, check that
conditions are as stated above and check that the guards
complete ly cover the rotating parts of the Cardan shaft.
The spare parts must correspond to the manufacturer's spe-
ENGLISH
4 cm 4 cm
L min.
B
D
CAUTION