Kimex 164-4920 Manual Del Usuario página 116

FACTORY
KEY
RESET
KEY standby
SETQUICKSTANDBY
(only hotel tv project)
GETQUICKSTANDBY
(only hotel tv project)
SETQUICKSTANDBY-
OPTION
GETQUICKSTANDBY-
OPTION
STANDBY
(only hotel tv project)
USBSWUPDATE
USBOPERATIONS
Load factory settings to
NVRAM.
Settings are updated with
defaults.
Clears flash.
Send key.
Reset the device.
Switch box to Standby
mode. ( For quick
standby)
SETQUICKSTANDBY
n, where n is one of (off,
on).
Returns Quick Standby
state n (on or off)
SETQUICKSTANDBY-
OPTION n, where n is
one of (OFF, ON).
Returns Quick Standby
option state (enabled or
disabled)
Switch box to Standby
mode.
( Attention: Television
cannot be opened with
standby command.
You should open it with
remote control.
If you use STANDBY
command, you will
need to establish the
connection again.
Tv state :HARD-
STANDBY )
Updates software from
usb and re-boots.
Perform USB Operations no parameter
English - 33 -
no parameter
string-integer n (n = 0, n = 1,
......, n = up, ......, n = menu,
.....ext.)
no parameter
no parameter
string-integer n (n = ON, n
= OFF)
no parameter
string-integer n (n = ON, n
= OFF)
no parameter
no parameter
no parameter
#*Factory Settings were loaded to
NVRAM.
n key sent
Reset process was successfully
accomplished. You need to
establish the connection again.
standby key sent
#*Set Quick Standby on
or
#*Set Quick Standby off
or
#*Quick Standby is not enabled
#*Quick Stanby is n
#*Set Quick Standby option ON
or
#*Set Quick Standby option OFF
or
#*Quick Standby option is ON or
OFF
or
#*Quick Standby Control is not
enabled
#*quick standby option is ...
#*enterLowPowerMode() returns
successfully.
or
#*enterLowPowerMode() returns
unsuccessfully!
or
#*enterStandbyMode() returns
successfully.
or
#*enterStandbyMode() returns
unsuccessfully!
upgradeSoftwareFromUSB
(frost_bool force:1)
Successfully written
or
no ... found
You may observe prints Bank 0,
Bank 1 etc. Be sure or observe
debug print outs: "MFC ISP: done"
will be writen... This may take over
10 minutes.