Kimex 164-4920 Manual Del Usuario página 121

ENTERACTIVESTANDBY
EXITACTIVESTANDBY
SWOL
GWOL
SETCUSTOMERNAME
GETCUSTOMER
screen_capture_usb
Command
set_IP_address
get_IP_address
SAVEWIFIPROFILE
Wifi
GETWIFIAPSSID
SETWIFIAPSSID
GETWIFIAPSECURITY-
TYPE
Enter active standby
state
Exit active standby state
Set Wake on Lan option
Get Wake on Lan option
Change or set the
Customer name
Get the Customer name
Capture specified surface
as bmp to USB stick.
NETWORK COMMANDS
Description
Set static IP address of
eth0 network interface.
Get IP address of eth0
network interface. Usage:
get_IP_address
Save access point to
wifi_profile.
checks if given SSID
wifi is found or not and
returns Pass or Fail.
Works only in portal
mode
returns the SSID of
access point
sets the SSID of access
point. SSID must be
maximum 32 characters
returns the security type
of access point
English - 38 -
no parameter
no parameter
integer n ( n = 1 (enable), n =
0 (disable))
no parameter
string - (customername)
no parameter
integer n (0 for UI, 8 for video
and OSD)
Parameter
str-int n Example: set_IP_
address 192.168.0.15
no parameter
str-int ssid, bssid key
str-int ssid
no parameter
string n (example 'AP-
ac:6d:bb:82:a8:ac' or
'486dbb82a89ac' )
no parameter
#*TV will be sent to Active Standby
state!
or
#*TV is in Active Standby state
already!
#* TV is not in Active Standby
state!
#*Wake on Lan is set to enable.
or
#*Wake on Lan is set to disable.
#*Wake on Lan is enable.
or
#*Wake on Lan is disable.
#*Customer name is set as
TOSHIBA (ie. TOSHIBA)
*Customer:TOSHIBA#* (ie.
TOSHIBA)
#*Screen capture is successfull.
or
#*Screen capture failed!
Return
#*IP address setting Succesfull
or
#*IP address setting NOK
#*IPaddr: ...
Profile saved.
or
Number of profiles exceeds the
maximum number to be stored.
#*Pass
or
#*FAIL
#*Current stored Wifi AP SSID is
(<SSID>)
#*Error! SSID can not be changed
when Access Point is active
or
#*Error! SSID parameter is too
long. Should be less than 32
characters
or
#*Wifi AP SSID is already
(<SSID>)
or
#*Setting Wifi AP SSID (<SSID>)
succeeded
#*Current stored Wifi AP Security
type is (<TYPE>)