Assembly; Fitting The J-Handle; Fitting The Suspension Ring; Assembling The Cutting Equipment - Husqvarna J-handle barrier 536LiLX Manual De Instrucciones

Fitting the J-handle

WARNING! Only grass blades/grass
!
cutters or trimmer heads/plastic blades
may be used when the J-handle is fitted.
Saw blades must never be used with the
J-handle.
Use the stop button to shut down the
machine. Use appropriate personal
protective equipment.
• Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
• Slide the spacer into the slot in the loop handle.
• Fit the nut, washer and screw. Do not overtighten.
• Attach the J-handle to the loop handle using the three
screws, as shown.
• Now carry out fine adjustment to give yourself a
comfortable working position. Tighten the screws.
6 – English

ASSEMBLY

Fitting the suspension ring

Fit the suspension ring between the rear handle and the
loop handle. Position the hanging ring so that the machine
is balanced and comfortable to work with.
Assembling the cutting
equipment
!
!
Assembly of grass blade and
grass cutter
• Hook the blade guard/combination guard (A) onto the
fitting on the shaft and secure with the bolt.
CAUTION! Use the recommended blade guard. See
the Technical data section.
• Fit the drive disc (B) on the output shaft.
• Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
WARNING!
When fitting the cutting attachment it is
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
WARNING! Never use a cutting
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.