Setting Up Your Multi-Touch Chassis Display; System Requirements; Unpacking Your Touch Display - 3M C3266PW Guia Del Usuario

279
Chapter 1

Setting Up Your Multi-Touch Chassis Display

To setup your display unit:
•
Unpack the components
•
Connect the video cable, touch display cables, and power cable
•
Power on the display and test your setup
•
If your operating system does not support native touch, install the MT7 software on
the enclosed CD.

System Requirements

This display requires a personal computer (PC).
•
Your PC must have an available USB port or RS-232 serial communication port
(C3266PW only). Connect the touch sensor cable to the communication port.
•
Your PC must have a pre-installed video card and video driver for the display.
Note: Before setting up your Multi-Touch Chassis Display, please refer to the
"Important Safety Information" section at the beginning of this document.

Unpacking Your Touch Display

Carefully unpack the carton and inspect the contents. Your Multi-Touch Chassis Display
includes the following:
USB Cable
VGA Cable
All manuals and user guides at all-guides.com
3M Touch Systems, Inc. Proprietary Information
3M™ Multi-Touch Chassis Display User Guide
9-pin RS-232 serial cable
(Qty 2 for C3266PW only)
DVI Cable