UFESA AS5200 Manual De Instrucciones página 15

Do not use the vacuum cleaner with no
inlet and outlet filters mounted in the
device.
Damaged inlet and outlet filters must be
always replaced with new, factory
original filters.
THE CONE OF "CYCLONE" DUST
CONTAIN
It is necessary to clean periodically the "CYCLONE"
dust container cone.
1
Disassembly "CYCLONE" dust container according
C
to point .
2
Press the button located on "CYCLONE" dust
container and open the bottom of the container.
If "CYCLONE dust container is full, empty it according
C
to the point .
3
Turn the cone left, so the two tips located on the
flange of the cone were put out from the slots of the
container. Put out the cone.
4
If the "CYCLONE" dust container cone (17) is dirty,
you can rinse it with running water. Do not forget to dry
above mentioned cone before re-installation.
5
Insert the rinsed cone of "CYCLONE" dust container
into the container slot so the tip located on the flange of
the cone was in the slot of container' s body. Turn right
the cone so that the two tips located on the flange of the
cone were blocked in the slots of the container.
6
Snap the bottom of "CYCLONE" dust container.
Please pay attention to the proper positioning of seal
found on the bottom of the container.
7
Insert "CYCLONE" dust container to vacuum
cleaner chamber. The characteristic "click" indicates
that the container has been correctly mounted.
End of operation, cleaning and
maintenance
1
Switch off vacuum cleaner pressing On/Off
switch (4).
2
Put the connection cable plug out the wall outlet.
3
Wind the cable by pressing retractor button (6).
Performing this action, hold the power cable to avoid
any tangles and shocking the vacuum cleaner body
with the plug.
4
Disconnect telescopic suction tube and a sucker or
a brush sweeper.
5
Disconnect telescopic suction tube and a hose.
6
Press the two side buttons located at the hose end,
then remove the hose end from vacuum cleaner inlet
hole.
7
Vacuum cleaner can be stored either in vertical
or horizontal position. The hose may remain attached
to the vacuum cleaner, but please note that the hose
should not be strongly bent during storage.
F
Storing in horizontal position:
– Insert a fixing hook of sucker-brush sweeper to
a hook for fixing the sucker-brush sweeper located
on the back of the vacuum cleaner over the outlet
filter cover.
Vertical storage:
– place the nozzle brush on the telescopic pipe,
– then insert the hook of the telescopic pipe into the
fastening situated on the bottom of the vacuum
cleaner, near the front wheel.
8
If necessary, clean the casing and the chamber
of the vacuum cleaner with a damp cloth (it may be
damped in dishwashing liquid), dry it off, and wipe it dry.
Do not use any scrubbing agents or
solvents.
Examples of problems you may
encounter when using the vacuum
cleaner
PROBLEM
A characteristic
fluttering in the
vacuum cleaner is
G
heard.
The vacuum
cleaner works less
efficiently.
SOLUTION
● Check the CYKLON
dust container and other
accessories. Remove the
reason for the clog-up or
empty and clean the CYKLON
dust container.
● Replace or clean the filters.
Empty and clean the CYKLON
dust container, replace or
clean the filters, check the
suction pipe, the hose, and the
nozzle – remove the reason
for the clog-up.