Technical Parameters; Static Electricity - UFESA AS5200 Manual De Instrucciones

●
Vacuum cleaner is a universal device with
a switchable sucking brush nozzle, which is used
for vacuuming hard floors and carpets.

Technical parameters

The type of the vacuum cleaner and the technical
parameters are indicated on the rating label. Mains
protection 16 A.
Does not cause interferences with audio/video devices.
The device meets the requirements of Commission
Regulation (EU) No. 666/2013 on implementing
the Directive of the European Parliament and of the
Council 2009/125/EC with regard to eco-design
requirements for vacuum cleaners.
The device complies with the requirements of the
Commission Delegated Regulation (EU) No. 665/2013
supplementing Directive of the European Parliament
and of the Council 2010/30/EU with regard to energy
labelling of vacuum cleaners.
Noise level: 77 dB(A).
This vacuum cleaner has a dust bin "CYCLONE" with
cyclone filtration, which allows vacuuming without the
use of a traditional bag. A characteristic feature of the
cyclone filter is the use the phenomenon of turbulence
of air stream for separating fixed impurities. Separation
of impurities occurs in the container part of circular cross
section, in which the rotating air moves the pollutions
on the wall of the container. The initially purified air is
targeted to the foam inlet filter and washable HEPA inlet
filter. For washable inlet filter HEPA was used a special
filtering material, which allows to rinse the filter with
running water after its dirty, and reuse of the filter.

Static electricity

In the process of vacuuming of some surfaces in areas
of low air humidity the device may become electrically
charged. It is a natural phenomenon – it does not
damage the device, and it is not considered to be a fault.
In order to minimize the phenomenon, we recommend
you to:
● discharge the device by touching metal items in the
room with the pipe,
● increase air humidity in the room,
● use widely available antistatic agents.
Structure of device
1
Outlet filter cover
2 A hook for mounting sucker-brush sweeper or
telescopic tube
3
A plug with power connecting cable
4 On/Off button and simultaneously a knob for
suction power control
5
Dust bin full indicator "CYCLONE"
6
Cable retractor button
7 An attach to unlock the dust bin "CYCLONE"
8
A handle for carrying vacuum cleaner
9
A bolt – mechanical suction power regulator
10
Suction hose
11
Telescopic suction tube with a fastening hook
12
Outlet filter "Microfilter" (mounted in a vacuum
cleaner)
13
Foam exhaust filter (mounted in vacuum cleaner,
in exhaust filter cover)
14
Inlet filter HEPA H13 (mounted in dust container
"CYCLONE")
15
Foam inlet filter (mounted in dust container)
"CYCLONE", in the inlet filter HEPA frame
16 Dust container "CYCLONE" (which is a removable
segment of the vacuum cleaner)
17
Dust container cone "CYCLONE" (mounted in dust
container "CYCLONE")
18
Switchable sucker-brush sweeper
19
Gap sucker
20
Small brush sweeper
21 Small sucker
22
"BNB" Parquet brush sweeper (Brush Natural
Bristle)
23 Turbobrush
Prepare the vacuum cleaner to use
1
Insert the tip of the suction hose to the vacuum
cleaner inlet. The characteristic "click" indicates
a properly fitted hose.
2
The second end of the hose (a handle) connect to
telescopic suction tube.
3
Set the telescopic suction tube to the desired
length by sliding the slider according with arrow and
put out / slide out the tube.
4
On the other end of the suction tube install the
appropriate sucker or brush.
A
B