Assembly; Unpack Electric Pressure Washer; Prior To Operation - Briggs & Stratton PW101-2010 Manual Del Operador

Assembly

Read entire operator's manual before you
attempt to assemble or operate your new
electric pressure washer.
Your electric pressure washer requires some assembly
but is quickly ready for use. If you have any problems with
the assembly of your electric pressure washer, please call
the electric pressure washer helpline at (800) 743-4115. If
calling for assistance, please have the model, revision, and
serial number from the identification label available.
Tools Needed
• Philips screwdriver #2

Unpack Electric Pressure Washer

1. Remove everything from carton.
2. Ensure you have all included items prior to assembly.
Items Included in the Carton
• Main unit
• Handle with accessory tray
• Handle support tubes (2)
• Spray gun
• High pressure hose
• Plastic wand
• Quick-connect spray tips (3)
• Spray tip holder
• Parts bag (which includes the following):
• Screws (3)
• Handle bolts (2)
• Plastic handle knobs (2)
• O-ring kit
• Nozzle cleaning tool
• Operator's manual
Check all contents. If any parts are missing or damaged, call
the electric pressure washer helpline at (800) 743-4115.
Become familiar with each component before assembling
the electric pressure washer. Identify contents with the
illustration shown in Features and Controls.

Prior to Operation

Read and perform the following instructions while paying
close attention to all warnings and notices.
NOTICE Connect ONLY to water source capable of
supplying a minimum of 3 GPM (11.4 l) and no less than
20 PSI (1.38 BAR) at the electric pressure washer end of
garden hose. Inspect all equipment, hoses and accessories
thoroughly before each use, DO NOT use if damaged.
• ONLY use branded accessories intended for use with this
product.
• For optimum performance, DO NOT use a garden hose
that exceeds 50 feet in length.
• Replace only with original equipment parts. To order, call
(800) 743-4115 or visit BRIGGSandSTRATTON.COM.
6
Attach Handle Support Tubes and Handle
1. Slide handle support tubes (A) into slots on back of
main unit. Align and attach handle support tubes with
a screw (B) on each side. Maintain alignment while
tightening with a #2 philips screwdriver.
A
B
2. Place handle (C) onto handle support tubes
connected to main unit. Make sure holes in handle
align with holes on handle support tubes.
3. Insert handle bolts (D) through holes from inside of
unit and attach a plastic knob (E) from outside of unit.
Tighten by hand.
D
4. Attach nozzle holder (F) with a screw (B) to back
of handle on left side. Tighten with a #2 philips
screwdriver.
F
B
C
BRIGGSandSTRATTON.COM
A
B
E