Connecting Your Tv With No Hdmi Input - Pioneer VSX-921-k Manual De Instrucciones

02 Connecting your equipment
02

Connecting your TV with no HDMI input

This diagram shows connections of a TV (with no HDMI
input) and DVD player (or other playback component) to the
receiver.
• With these connections, the picture is not output to the
TV even if the DVD player is connected with an HDMI
cable. Connect the DVD player's video signals using a
composite or component cable.
• Connect using an HDMI cable to listen to HD audio on the
receiver. Do not use an HDMI cable to input video signals.
Depending on the video component, it may not be
possible to output signals connected by HDMI and other
methods simultaneously, and it may be necessary to
make output settings. Please refer to the operating
instructions supplied with your component for more
information.
• If both TV and player has a component video jacks, you
can connect these too. See Using the component video
jacks on page 19 for more on this.
Note
• In order to listen to the audio from the DVD player that is
connected to this receiver using an optical cable or a
coaxial cable, first, switch to the DVD input, then use
and SIGNAL SEL to choose the audio signal O2
RECEIVER
(OPTICAL2) or C1 (COAXIAL1) (see Selecting the audio
input signal on page 25).
16
En
HDMI HDMI DVR/BDR IN
VIDEO
MONITOR
OUT
DVR/
BDR
OUT
IN 1
( DVD )
ASSIGNABLE
IN 2
( DVR/
BDR
)
MONITOR
OUT
Y
COMPONENT VIDEO
OPTICAL
R
DIGITAL AUDIO OUT ANALOG AUDIO OUT
VIDEO IN
Select one
This connection is
required in order to
listen to the sound of
the TV over the
receiver.
TV
COAXIAL
OUT
DVD IN BD IN BD IN VIDEO 1 IN
IN 1
ASSIGNABLE
( CD )
AUDIO
DVR/BDR CD-R/TAPE
ADAPTER PORT
L
TV/SAT BD
( OUTPUT 5 V
IN IN
OUT
0.1 A MAX )
R
ANTENNA
CD
FM UNBAL
75
L
AM LOOP
SIRIUS
A
IN DVD IN IN IN
R
R
IN
L
IN IN
R
SUBWOOFER
P P TV/SAT BD DVD
B R
PRE OUT
L
VIDEO OUT
R
ANALOG AUDIO OUT
DVD player
OPTICAL
IN IN
1 2 ASSIGNABLE
( TV/SAT ) ( CD-R/TAPE )
FRONT CENTER
L
L OPTICAL COAXIAL
DIGITAL AUDIO OUT HDMI OUT
Select one