Gree GKH(12)BB-K6DNA3A El Manual Del Propietario página 11

8
button
Press this button can select up&down swing angle. Fan blow angle can be selected
circularly as below:
● When selecting "
louver will automatically swing up & down at maximum angle.
● When selecting " 、
position. Horizontal louver will stop at the fixed position.
● When selecting "
Horizontal louver will send air at the fixed angle.
● Hold " "button above 2s to set your required swing angle. When reaching your
required angle, release the button.
Note:
● " 、 、 " may not be available. When air conditioner receives this signal, the
air conditioner will blow fan automatically.
9
CLOCK button
Press this button to set clock time. "
"+" or "-" button within 5s to set clock time. Each pressing of "+" or "-" button, clock
time will increase or decrease 1 minute. If hold "+" or "-" button, 2s later, time will
change quickly. Release this button when reaching your required time. Press
"CLOCK" button to confirm the time. "
Note:
● Clock time adopts 24-hour mode.
● The interval between two operation can't exceeds 5s. Otherwise, remote contro-
ller will quit setting status. Operation for TIMER ON/TIMER OFF is the same.
10
TIMER ON / TIMER OFF button
● TIMER ON button
"TIMER ON" button can set the time for timer on. After pressing this button, "
icon disappears and the word "ON" on remote controller blinks. Press "+" or "-"
button to adjust TIMER ON setting. After each pressing "+" or "-" button, TIMER
ON setting will increase or decrease 1min. Hold "+" or "-" button, 2s later, the
time will change quickly until reaching your required time.
Press "TIMER ON" to confirm it. The word "ON" will stop blinking. "
resumes displaying. Cancel TIMER ON: Under the condition that TIMER ON is
DC Inverter Free match Series Cassette Type Unit
no display
(horizontal louvers stops
at current position)
", air conditioner is blowing fan automatically. Horizontal
、 、 ", air conditioner is blowing fan at fixed
、
、 、 " , air conditioner is blowing fan at fixed angle.
" icon on remote controller will blink. Press
" icon stops blinking.
7
"
" icon