Others - Pioneer BDP-88FD Manual De Instrucciones

Others

Problem
Power does not turn on.
The player's power turns off
automatically.
The player's power turns on
automatically.
This unit cannot be operated.
The player cannot be
operated with the remote
control.
Unit heats up during use.
Input of the connected TV
and AV system switches
automatically.
Settings I have made have
been cleared.
USB (external storage) device
does not work with this player
properly.
Check
Is the power cord properly
connected?
Is Auto Power Off set to 15
min or 30 min?
Is Control set to On?
Are you operating the remote
control from a point too far
away from the player?
Are the batteries dead?
Is Control set to On?
• Have you disconnected the
power cord while the player's
power was on?
• Has there been a power
failure?
Is the USB device properly
connected?
Is the USB device connected
via an extension cable?
Is the external storage device
connected to the USB port via
a memory card reader or USB
hub?
Does the external storage
device contain multiple
partitions?
Is the external storage device
write-protected?
Is the USB device's file
system FAT32, FAT16 or
NTFS?
Remedy
• Plug the power cord securely into the power outlet (page 23).
• Unplug the power cord, wait several seconds, then plug the power
cord back in.
If Auto Power Off is set to 15 min or 30 min, the player's power
automatically turns off if no operation is performed for the set amount
of time (page 46).
The player's power may turn on together with the power of the TV
connected to the HDMI OUT terminal. If you do not want the player's
power to turn on when the TV's power is turned on, set Control to Off
(page 44).
• Use within the specified usage temperature range (page 64).
• If the power cannot be turned off (to standby), reset the unit. Press
and hold  STANDBY/ON on the main unit's front panel for over 5
seconds. The unit restarts and can now be operated.
Operate from within 7 m (23 ft.) of the remote control sensor.
Replace the batteries (page 6).
Depending on the usage environment, the temperature of the unit's
cabinet may increase somewhat during use, but this is not a
malfunction and there is no need to worry.
The input of the TV and AV system (AV receiver or amplifier, etc.)
connected to the HDMI OUT terminal may automatically switch to the
player when playback starts on the player or the menu screen (Source
function, etc.) is displayed. If you do not want the inputs of the
connected TV and AV system (AV receiver or amplifier, etc.) to switch
automatically, set Control to Off (page 44).
Always press  STANDBY/ON on the player's front panel or
 STANDBY/ON on the remote control and check that POWER OFF
has turned off from the player's front panel display before
disconnecting the power cord. Be particularly careful when the power
cord is connected to the AC outlet on another device because the
player turns off in conjunction with the device.
• Turn the player's power off, then turn the power back on.
• Turn the player's power off, then reconnect the external storage
device (page 22).
Do not use an extension cable. The player may not work properly with it.
External storage device may not work if connected to the USB port via
a memory card reader or USB hub.
External storage devices may not be recognized if they contain multiple
partitions.
Turn the player's power off, then disable the write-protection.
USB devices formatted in the FAT32, FAT16 or NTFS file system can be
used.
Some external storage devices may not operate.
09
61
En