Changing The Video Options; Operating The Video Parameter Screen - Pioneer BDP-88FD Manual De Instrucciones

07
1 This is effective only on audio output from ANALOG AUDIO OUT terminals.
2 • This can be set when Manual is selected for Audio Scaler.
• This function does not work when the sampling frequency is 32 kHz.
3 • This setting only affects 2-channel audio sources.
• This function does not work when the Auto Sound Retriever setting is On.
4 The sound may be interrupted while setting the delay.
5 This is the Audio Sync setting which you can set only when Auto is selected. The set value is reflected after you stop or pause playing and
play again.

Changing the Video options

There are a number of additional picture settings you can
make using the Video Parameter menu.
TOP MENU
HOME MENU
Note
• It is not possible to open the Video Parameter screen when any of the Home Menu (Source, Web Contents, Initial
Setup), Audio Parameter, Function Menu, Disc Menu, YouTube or Picasa is being displayed.
• It is not possible to open the Video Parameter screen while 3D contents are being played back.
• Video Parameter options do not affect Blu-ray 3D pictures.
• The Video Parameter option is not effective when the HDMI Mode is set to Pure Audio.
• In Options, the factory default settings are indicated in bold.
Setting
Video Adjust
1
Progressive Motion
Pure Cinema
Stream Smoother
2
Film Grain
1 • Progressive Motion is disabled when Pure Cinema is set to On.
• This setting have the effect only for pictures recorded in the interlaced scan format (480i/576i or 1080i signals).
2 The Film Grain function is effective on all videos, including on the Home menu screen.
40
En
AUDIO P. VIDEO P. CONTINUED
YouTube SOURCE
POPUP MENU
POP
TOP
UP
ENTER
RETURN
Options
PJ Digital Cinema
PJ Film Cinema
PJ Live
FPD Digital Cinema
FPD Film Cinema
FPD Live
Reference
Memory 1 to 3
–4 to +4 (Default 0)
Auto
On
Off
Off
On
0 to +8 (Default 0)
Operating the Video
Parameter screen
1 Press VIDEO P. to display the Video Parameter
screen.
Use / to select the setting you want to adjust,
2
then press ENTER.
Use / to set as necessary, then press ENTER.
3
 Closing the Video Parameter screen
Press VIDEO P. or
Explanation
Selections are made to suit the audio visual equipment in use and the material
to be viewed and heard.
Select either the PJ mode for viewing with a projector or the FPD mode for
viewing with a flat panel television set. Select Digital Cinema when viewing the
latest movies with CGIs and digital processing, Film Cinema when viewing
conventional analog movies on film, and Live when viewing concert video.
The Reference mode is a setting that inhibits video signal processing. This
mode is selected when viewing the source as it is.
If you want to adjust the picture quality settings to your personal tastes, select
Memory 1 to Memory 3 (see Adjusting the video on page 41).
Adjusts the motion and still picture quality when video output is set to
progressive.
This setting optimizes the operation of the progressive scanning circuit for
playing film materials. Normally set it to Auto. If the picture seems unnatural,
switch this to On or Off.
Use the image quality of the built-in circuit, make the image quality correction
reduce block noise and mosquito noise, and improved sharpness feeling. This
is effective for playing online or low bit rate video contents.
Adds small particles of noise to give the effect of a movie film. The greater the
number, the higher the granular quality.
RETURN.