Cleaning And Lubrication; Dismantling And Disposal - Sincro HB Serie Manual De Uso Y Mantenimiento

• - Insert the cables of the main rotor in the exciter rotor
• Insert the exciter rotor (by hand, or with the help of a
rubber hammer)
• Insert the screw (2), screw it into the tab (with thread
lock) and tighten it following the torque values shown
in paragraph 6.2.4
• Reconnect the diode bridge observing the polarities
• Replace the bearing shield and protective grid.
FAN
2
1

8. CLEANING AND LUBRICATION

Any kind of cleaning work must be carried
out with the gen er at ing set shutdown and
the mains power shut off for the risk of
WARNING!
severe hazard for persons and objects.
Make sure that the generating set is shutdown and the
mains power is shut off before cleaning the outside of
the generating set with compressed air.
Never and for no reason whatsoever use
fl uids or water. Do not use compressed
air to clean internal electrical parts since
this could cause short circuits or related
WARNING!
problems.
ROTOR
EXCITER
1 2

9. DISMANTLING AND DISPOSAL

Only use authorised specialists.
WARNING!
All material should be eliminated in compliance with
statutory regulations.
The generator does not present any particular risks
or hazards during dis man tling. To aid recovery of the
material, it is best to classify it by type (i.e. electrical
parts, copper, aluminium, plastic, etc.).
27