Assembly Format Sae; Assembly Format Im35 - Sincro HB Serie Manual De Uso Y Mantenimiento

6.2.1 Assembly format SAE

• Remove the protective grids (6). For the SAE3
version, remove the plastic caps (7) on the bell to give
easier access when mounting the 11.5 disk;
• Make sure the diameter of the disk (3) corresponds
with the diameter of the seat in the flywheel (2);
• Anchor the generator to the engine by locking the
SAE bell (4), making sure that the holes in disk and
flywheel are aligned;
• Check that the exciter rotor and stator are perfectly
aligned;
• Mount the assembly on antivibration plugs (5) making
sure that engine and generator are level;
• Fit the plastic caps (7) on the bell (only on version
SAE3) and fasten the grids (6).
6
7
3
2
Inadequate
alignment of the generator can cause
injury and/or damage to equipment.
WARNING!
6
5
4
protection and/or bad

6.2.2 Assembly format IM35

• Remove the protective grilles (6).
• Fasten the shield (1) to the motor (after having
removed it from the alternator).
• Apply the tie rod (2) that anchors the rotor axially by
screwing it onto the external section of the motor shaft.
• Anchor the complete generator assembly (i.e. stator
and rotor) to the shield using the 4 self-locking nuts (3).
• Check that the cone couplings of rotor and motor have
made contact by hammering the rotor axially with a
plastic mallet and block.
• Lock axially the rotor by turning the self-locking nut
(4) on the tie rod (2).
Before fastening the nut check that part of
the threaded section of the tie rod enters
the rotor thereby obtaining a sound hold.
CAUTION!
• Check that exciter rotor and stator are perfectly
aligned.
• Mount the assembly on antivibration plugs (5) making
sure that motor and generator are level.
• Replace the grilles (6).
1
3
2
4
5
6
6
6
21