Panel Description - Cebora TIG 438 Manual De Instrucciones

5

PANEL DESCRIPTION

AP
AO
AN
BA
AN Knob
Selects LEDs AO AP AQ and sets their value, which is shown on display AR.
AO LED Pulsed (see instructions for robot power source 3301062 or manual power source 3301017)
AP LED Wire speed
This indicates that display AR shows welding wire speed in metres per minute if WF5 COLD WIRE wire feeder item
no 8164900 for cold wire TIG is installed.
AQ LED Welding current
This indicates that display AR shows the welding current in amps.
AR Display
This shows the value of magnitudes adjusted by means of knob AN.
AW Knob
Selects LEDs AV AU AT and sets their value, which is shown on display AS.
AS Display
This shows the value of magnitudes adjusted by means of knob AW.
AT LED Welding voltage
This indicates that the value shown on display AS is a voltage expressed in volts.
During the welding process, the value shown on display AS is always the voltage measured by the power source.
AU LED Plasma gas test
In Plasma Welding mode, combined withconsole item no 46501.
AQ AR
BC BD BE BF
AS
BG BH BI BL
AT
AU
AV
AW
BB
19/24