Installation - AERMEC CHF 17 Manual De Instrucciones E Instalación

INSTALLATION

Remember that the cassaforma is an assembly template only,
so it is not load-bearing; inclusion of an appropriately sized
structure is recommended to support the wall above the cas-
saforma itself.
The construction of the niche where the Ventilcassaforma
system is to be mounted must take into consideration the
following:
1 - create the niche according to the size of the CHF template
2 - for the empty spaces (e.g. between the CHF and the
architrave), use building material
3 - use an architrave to reduce the weight of the wall on the
CHF template
4 - use a suitably sized isolating panel to isolate the
Ventilcassaforma system
The figure shows the fixing system of the front closure panel.
ACHFUJ 1103 - 4689580_01
14
We recommend that you paint the front panel and closure
boards before the pieces are assembled.
When assembling the indoor unit, you will have to
temporarily remove the anti-deformation bars and/or the
external frame to facilitate installation operation (as shown
in the figure).
Installing the recessed CHF box.
Pay attention to the dimensions of the external frame.
The figure shows the final result of a correct assembly.