Install The Side Discharge Chute; Set The Cutting Height; Install The Battery Packs - GreenWorks MO48L4423 Manual Del Operador

EN
3. Hold the mulch plug (13) by its handle and fit it in the
discharge chute.
4. Close the rear discharge door.
7.6 INSTALL THE SIDE DISCHARGE
CHUTE
20
12
When you use the side discharge chute,
• Do not install the grass catcher.
• Keep the mulch plug installed.
1. Open the side discharge door (20) and hold it.
2. Line up the recesses of the side discharge chute (12)
below the pivot (21).
3. Close the side discharge door.
7.7

SET THE CUTTING HEIGHT

The machine can be set to different cutting height.
1. Pull the height adjustment lever (7) rearward to increase
the cutting height.
2. Pull the height adjustment lever forward to decrease the
cutting height.
21
CAUTION
7
English
7.8

INSTALL THE BATTERY PACKS

THIS MOWER MUST HAVE TWO BATTERIES TO RUN!
29
10
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery
and charger manual.
The machine has an automatic switch function that lets the
other two battery packs work when the first two battery
packs are depleted.
Optimize the power and performance of your new 2x24
mower by running with both batteries charged to 100%.
1. Open the battery door A (8).
2. Align the ribs on the battery pack (28) with the grooves in
the battery compartment.
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door A.
6. Follow the same operations to install the battery packs in
the other compartment.
The motor starts only when you put in the safety key (30).
10
30
WARNING
NOTE
IMPORTANT
NOTE
8
28