DJI DATALINK PRO Guia De Inicio Rapido página 4

Disclaimer
Thank you for purchasing the DATALINK PRO (hereinafter referred to as
"product"). Read this disclaimer carefully before using this product. By using
this product, you hereby agree to this disclaimer and signify that you have
read it fully. Please install and use this product in strict accordance with this
manual. SZ DJI Technology Co., Ltd. and its affiliated companies assume
no liability for damage(s) or injuries incurred directly or indirectly from using,
installing or refitting this product improperly, including but not limited to using
non-designated accessories.
DJI TM is a trademark of SZ DJI Technology Co., Ltd. (abbreviated as "DJI")
and its affiliated companies. Names of products, brands, etc., appearing
in this manual are trademarks or registered trademarks of their respective
owner companies.
This product and manual are copyrighted by DJI with all rights reserved. No
part of this product or manual shall be reproduced in any form without the
prior written consent of or authorization from DJI.
This disclaimer is produced in various languages. In the event of variance
among different versions, the Simplified Chinese version shall prevail when the
product in question is purchased in Mainland China, and the English version
shall prevail when the product in question is purchased in any other region.
Warnings
1. Only use the DATALINK PRO in the corresponding frequency band and
in accordance with local laws and regulations.
2. Ensure all modules are connected and the parameters are set correctly
in DJI Assistant 2 when using the DATALINK PRO for the first time.
3. DO NOT bend or fold the antennas excessively.
4. Ensure the antennas for both the Mobile Device and the Base Station
are unobstructed when used.
5. Only use the DATALINK PRO in an open environment free from radio
interference.
6. Only pair the DATALINK PRO Base Station with a Mobile Station in the
same frequency band. Note that the DATALINK PRO 400 and DATALINK
PRO 900 are not compatible.
7. When upgrading the firmware, toggle the 4-position switch to the
COMBO_SW4 position, connect the module to the PC, and then run DJI
Assistant 2.
8. To avoid interference, DO NOT use a two-way transceiver or walkie-talkie
operating near the 400 MHz band when operating the DATALINK PRO 400.
9. Only use genuine DJI parts or parts certified by DJI. Unauthorized
parts or parts from non-DJI-certified manufacturers may cause system
malfunctions and compromise safety.
10. Ensure the DATALINK PRO and its components are free from
contamination (e.g. water, oil, soil and sand).
11. Download the latest version of the user manual or software for any
related DJI product that is required when using this product.
© 2017 DJI All Rights Reserved.
2