Equipment Description; Installation; Operation - J.P. SELECTA CENCOM 2 Manual De Instrucciones

INSTRUCTION MANUAL CODE 80044 REV D
CAUTION!!! IMPORTANT FOR YOUR SAFETY
4. Display:
hh:mm
r.p.m.
J
.P. SELECTA s.a.u.
January/2020

4. EQUIPMENT DESCRIPTION

CENCOM 2 is a benchtop centrifuge with an angle head of 6 x15ml
tubes. It is supplied with a safety cover and 8 speed positions.

5. INSTALLATION

Place the centrifuge on a flat, horizontal, level surface.
Connect the cable into the mains.
Do not use the equipment to centrifuge liquids which are
susceptible to form explosive mixtures.
In case of centrifuging microbiological products susceptible
to contamination or being contaminated, it is advisable to use
tubes with a stopper.
Be sure that the voltage supply is the same as the one
indicated on the characteristics plate of the equipment.
Do not use the equipment if it is NOT EARTHED.
If you have to change the plug bear in mind the following:

6. OPERATION

CONTROL PANEL:
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - http://www.jpselecta.es
(It can be modified without notice)
Blue cable:
Brown cable:
Yellow/green cable:
1. Increase / decrease r.p.m. or time.
2. Start / Stop key.
3. Switch r.p.m. or time.
Tel (34) 93 770 08 77 Fax (34) 93 770 23 62
Page: 9
Neutral.
Phase.
Earth.