Connecting Power - Brady BBP 35 Guia De Inicio Rapido

26 Setting Up the Printer
Setting Up the Printer

Connecting Power

Before connecting power, be sure to remove any transportation protection from around the
printhead and inside the enclosure cover.
1. Plug the power cord into the power cord
connection port on the right side of the printer, then
plug the other end of the cord into an AC power
outlet.
2. Turn the power switch to ON.
Installing Ribbon
Illustrations on the inside of the cover show how to
install the ribbon and label media (tape).
1. Open the cover by pulling up on the bottom of the yellow latch.
The cover pops open quickly. To ease the opening, place a hand on the
cover as you release the latch.
2. With the cartridge tab on top, facing outward, place the exposed ribbon over the print head, then
push the cartridge forward until it snaps into place.
1
®
BBP 35/37 Quick Start Guide
CAUTION CAUTION
2
3/2/15