Unpacking The Device; Power Sources - LEXIBOOK RCD102 Serie Manual De Instrucciones

Ocultar thumbs Ver también para RCD102 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 19
24. Mains plug is used as disconnect device and it should remain readily accessible during
intented use. In order to disconnect the apparatus from the mains completely, the mains plug
should be disconnected from the main socket outlet completely.
25. Minimum distance 10 cm around the apparatus for suficient ventilation.
26. No naked lame sources such as lighted candles should be placed on the apparatus.
27. Attention should be drawn to the environmental aspects of battery disposal.
28. Use the apparatus in moderate climates.
29. Excessive sound pressure from earphones and headphones can cause hearing loss.
30. Maximum output voltage: ≤ 150mV.
31. Batteries shall not be exposed to excessive heat such as sunshine, ire or the like.
32. Caution marking is located at the bottom of the apparatus.
33. The marking information is located at the bottom of the apparatus.
When unpacking, ensure that the following elements are included:
1 x Boombox CD Player
1 x AC cable
1 x Instruction manual
WARNING: All packaging materials, such as tape, plastic sheets, wire ties and tags are not
part of this product and should be discarded.
The Radio CD Player operates on AC 230V ~ 50Hz or with 6 x 1.5V
batteries (not included).
AC operation
1. Check that the unit is switched off.
2. Insert the small end of the AC cord into the AC socket at the back of the unit.
3. Plug the other end of the AC cord into any convenient mains power socket.
4. STANDBY Indicator is light up in half brightness and unit is in standby mode.
Battery installation
1. To install the batteries, open the battery compartment located at
the back of the unit by pressing in on the tabs, then lifting it off.
2. Insert 6 x 1.5V
the polarity indicated in the compartment, and as per the diagram
shown opposite.
3. Close the battery compartment.
4. STANDBY Indicator is light up in half brightness and unit is in
standby mode.
Note: The AC power cord must be disconnected from the AC socket on the rear of the unit in
order for the product to operate on battery power.
RCD102seriesIM1084_19Feb_V10.indd 13

UNPACKING THE DEVICE

POWER SOURCES

C/LR14 size batteries (not included) observing
13
13
C/LR14 size
19/02/2014 3:14 PM

Publicidad

Tabla de contenido
loading

Tabla de contenido