Aux In Operation - LEXIBOOK RCD102 Serie Manual De Instrucciones

Use the program function to preselect the order in which a sequence of tracks will be played.
Up to 20 tracks can be programmed.
1. Slide the FUNCTION selector to the CD position.
2. Press MODE, program indicator will light and "01" will blink on the LED display.
3. Use SKIP FORWARDS or SKIP BACKWARDS to select the irst track to include in the
programmed sequence.
4. Press MODE to conirm and store the track.
5. Repeat steps 3 and 4 to program the other desired tracks.
6. Press PLAY to begin playback. The tracks will be played in the programmed order. The
PLAY/PAUSE/PROG indicator lashes when the program function is in use.
Note:
• To cancel the program function, press the STOP button until the PLAY/PAUSE/PROG
indicator goes off.
• During program setting, press STOP or open the CD door.
You can play music through the speakers of this Radio CD Player by connecting its AUX IN
jack to your MP3 or other digital audio player.
1. Plug one end of an audio cable (not included) into the AUX IN jack located at the back of
the unit, and the other end of the cable to the line out jack of the device you want to connect.
2. Slide the FUNCTION selector to the AUX position.
3. Adjust the VOLUME control to your desired listening level.
4. Use the function keys of your audio device to pause and resume the playback, adjust the
volume and select the next or the previous track.
5. To switch off the unit, remove the plug from the AUX IN jack, then press the standby
button.
Turn the unit volume to minimum before connecting your headphone (not included) to the
headphone jack. Headphones should have a 3.5mm diameter stereo plug and an impedance
of 8 – 32 ohms. When headphones are connected, the speakers are automatically
disconnected.
Note:
Extended listening of music at high volume may damage your hearing. It is highly
recommended to use at comfortable volume levels.
RCD102seriesIM1084_19Feb_V10.indd 17
CD PROGRAMMED PLAY

AUX IN OPERATION

HEADPHONE OPERATION
17 17
19/02/2014 3:14 PM