Connecting The Water Supply; Connecting The Drain Hose - Brandt WFH 1270 K Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Loosen the locking nuts on the feet
with the open ended spanner.
2. Adjust feet until the appliance is level
and does not rock.
3. Important: Tighten all locking nuts af-
ter the machine has been levelled.

Connecting the water supply

This appliance can be connected to water
tabs with a 3/4" B.S.P. thread.
Important:
• Observe the permissible water pres-
sure and the max. inlet temperature
(see "Technical Specifications"). Install
a pressure reducing valve if the water
pressure is higher.
• Do not connect to a water heater (in-
stantaneous water heater or unpressu-
rised boiler), as the water pressure is
insufficient.
• Check with customer service for hose
extensions. Do not use homemade ex-
tensions with hose clamps or similar!
• Use only the new hose supplied with
the machine, not an old existing one!
• Ensure that there are no sharp bends
in the hose!
Required tools: None. (Do not use a pipe
wrench!)
1. If not already mounted, the offset side
of the inlet hose is to be screwed "fin-
ger-tight" to the water inlet port at the
rear of the appliance.
2. Connect the other end of the inlet
hose "finger-tight" to the water tap.
3
The "Aquastop" resp. "Aquastop PLUS"
(according to model) turns off the wa-
ter inlet, if a leakage occurs.
3. Open the water tap fully and check all
connections for tightness; close water
tap again. Correct the position of seals
and screw couplings, if necessary.

Connecting the drain hose

The drain hose can be hung to a wash-ba-
sin, sink or bathtub – or connected perma-
nently to a siphon trap.
Important:
• Do not run the drain hose higher than
100 cm above floor level for the suds
pump to be able to pump out.
• The water must be able to run off un-
hindered. Washbasins with a small
drain are not suitable.
• The end of the hose must not im-
merge in the pumped-out water.
• Check with customer service for hose
extensions. Do not use homemade ex-
tensions with hose clamps or similar!
• Use only the new hose supplied with
the machine, not an old existing one!
• Ensure that there are no sharp bends
in the hose!
Fastening the hose holder:
1. Pull the hose holder supplied over the
end of the drain hose.
Aquastop /
Aquastop PLUS
45
G

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Wfh 1670 k

Tabla de contenido