Electrical Connection - Brandt WFH 1270 K Manual De Instrucciones

2. Hang drain hose with hose holder on
the edge of basin or tub and secure
against slipping off – e.g. with a chain
tied around the water tap.
Permanent connection to a siphon trap:
A
The connection should be made by a
qualified plumber, to prevent the hose
from slipping off. Risk of flooding!
• Install the rubber hose supplied be-
tween drain hose and siphon trap and
secure with two hose clamps. Hose
clamps are available at specialized
dealers.

Electrical connection

Connect the appliance to a properly in-
stalled earthed outlet, which is protected
by a fuse of adequate capacity.
Important:
• The connection must conform to the
applicable regulations in your country
and your local electricity board.
• The power cable plug must be accessi-
ble after installation.
• For a firmly fixed connection a master
switch with at least 3 mm contact
clearance must be used.
• Voltage and rated fuse protection of
the appliance are shown on the rating
label at the rear.
G
46
3
Note down the appliance's model and
Identification number from the rat-
ing label, in case you need help from
customer service.
• The stated voltage must match with
your mains voltage.
• Connection by extension cables or trail-
ing sockets is inadmissible.
• When connecting to the mains the
programme selector must be in the
»Stop« position.
B
A damaged power cable must be re-
placed by an authorised qualified elec-
trician. Until the appliance has been
repaired it must not be operated! Risk
of electric shock!
The right plug
This appliance comes with a fitted plug.
If this plug is not suitable for your socket
outlet, it must be cut off and the appropri-
ate plug fitted (see below). The cut off
plug should be disposed of immediately to
prevent the possibility of electric shocks,
should it be plugged into a socket.
In the event of losing the fuse cover, the
plug must not be used until a replacement
fuse cover has been fitted; it can be ob-
tained from your nearest electrical dealer.
The colour of the correct replacement fuse
cover is that of the coloured marks or in-
serts in the base of the plug.
If the plug fitted is the moulded on type,
the fuse is a 13 amp ASTA approved fuse
to BS 1362.
With alternative plugs a 15 amp fuse must
be fitted either in the plug or in the mains
fuse box.
Fitting a different plug
The wires in the mains cable are coloured
in accordance with the following code:
Green and Yellow – Earth
Blue – Neutral
Brown – Live