At A Glance; Preparation And Start; Changing A Programme; Aborting A Programme - Brandt WFH 1270 K Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

AT A GLANCE

Preparation and start

1. Open water tap fully. Check to see
that all hoses are tight.
2. Place laundry in the drum.
3. Fill in detergent and fabric condition-
er.
4. Set the programme selector.
5. If desired:
– activate any additional function(s),
– set the spin speed,
– set a delayed start.
6. Press the »Start/Pause«
(except for delayed start).
In the display the end-of-programme
time is shown.

Changing a programme

1. Set the programme selector to »Stop«,
then wait approx. 2 seconds.
2. Set the programme selector to the
new programme.
3. Press the »Start/Pause«

Aborting a programme

1. Set the programme selector to »Stop«,
then wait approx. 2 seconds.
2. Set the programme selector to »Spin/
Drain«
.
3. Press the »Start/Pause«
4. Wait for the programme cycle to end.

Adding more laundry

3
This is only possible during the time-
delay period.
1. Open the door and add laundry.
2. Close the door.

Programme halted by rinsehold

3
If you wish to spin:
1. Set the spin speed.
2. Press the »Rinse & hold«
If you wish to pump out only:
1. Set spin speed selector to »No spin«
2. Press the »Rinse & hold«
button

Spinning the laundry again

3
If you wish to spin again:
1. Set the programme selector to »Stop«.
2. Open the door and rearrange the
button.
3. Set the programme selector to »Spin/
4. Set the spin speed.
5. Press the »Start/Pause«
After completion of the programme
cycle
button.
3
1. When the »Door locked«
2. Set the programme selector to »Stop«.
3. Close tap.
4. Wipe out the sealing fold of the rub-
5. Leave door and detergent dispensing
This condition is indicated by flashing
»Rinse & hold«
cator lamps.
The programme is continued, pumps
out and spins.
The programme is continued, only
pumping the water out.
The automatic spin-correction-system
can prevent the spinning if the drum is
out-of-balance.
laundry evenly in the drum.
Drain«
.
When the programme sequence indi-
cator »Stop« goes on, the programme
is completed.
The display will then show the current
time again.
tor lamp goes out, open the door and
remove the laundry.
ber collar; check sealing fold and
drum for foreign matter.
drawer open for drying out.
and »Pause« indi-
button.
.
button.
button.
indica-
G
55

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Wfh 1670 k

Tabla de contenido